Follow

ELR Humming Instead of Retracting

Answer

Check These Things: 

  1. Humming is typically indicative of a mechanical bind the ELR solenoid assembly cannot overcome. This could be the latches rubbing the strike, (if there are vertical rods) the rods not centered or slightly askew or the top rod is out of adjustment.

  2. The pin on the yoke assembly is either misaligned, rubbing or burred. (See Image in Additional Information Section Below)

  3. Humming can also be from too much resistance in the wiring. to confirm this,with the power to the ELR150 power supply turned off check on pins 1&2 (white wires) on terminal block 2, check the ohms, it should be between 4.5 - 6 ohms.

Applies To

 ELR, Electric Latch Retraction, APEX 2000

Additional Information

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Limited Warranty on Information: The documents contained on this website are distributed as is, without warranty of any kind, either express or implied, including but not limited to implied warranties for the document’s quality, performance, merchantability, or fitness for any particular purpose. Neither Stanley Security Solutions, Inc., nor its dealers or distributors shall be liable to the user or any other person or entity with respect to any liability, loss, nor damage caused or alleged to be caused directly or indirectly by this information.