Follow

When I turn the key my Arm-A-Door is not arming.

Answer

Possible Causes:

  1. There is not any power going to the unit.
  2. The unit is not armed.
  3. The subassembly is damaged or gone bad

Possible Solutions:

  1. Verify there is power to the unit (fresh 9 volt batteries). Try resetting after installing new batteries.
  2. Verify the Key cylinder is engaging the microswitch. Verify the microswitch at the key cylinder is good.
  3. The subassembly is bad and will need to be replaced.
Applies To
Additional Information
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Limited Warranty on Information: The documents contained on this website are distributed as is, without warranty of any kind, either express or implied, including but not limited to implied warranties for the document’s quality, performance, merchantability, or fitness for any particular purpose. Neither Stanley Security Solutions, Inc., nor its dealers or distributors shall be liable to the user or any other person or entity with respect to any liability, loss, nor damage caused or alleged to be caused directly or indirectly by this information.